|
The BB and HD are 48" wide. Either will fit between the wheel wells, headboard to tail gate of a standard pick up truck. The CB toolboxes are 40” wide and will fit between the wheel wells of import and compact trucks. The N series toolboxes are only 24” wide and will fit in either type of truck. The difference between them is the glide system of the drawers. |
||
 This picture shows the rollers mounted to the under carriage of an HD |
The HD drawer is on rollers. It is designed to carry very heavy loads. The rollers under the drawer make the box 14 3/16" tall. Properly loaded, on level ground you can put 500# in each drawer. You can see the HD drawer load test at www.hmfinc.com/HD_test.html. |
||
 This is a view of the Teflon strips inside of a BB Series toolbox. |
The BB, CB, and N series boxes are 10 5/8" tall. The drawers slide on three Teflon strips that run the length of the drawer. The drawers are designed to carry lighter loads. You can see the drawer load test at www.hmfinc.com/BB_test.html. | ||
|
The wheel wells of most pick up trucks are about 10 " tall. The "deck" of the BB is just a little above the wheel well. The deck of the HD is about 4" above the wheel well. The deck of either box can carry a 1000# load on a skid 4’ square. The 96” long boxes are big enough for two skids. That means 2000# on the deck. To see more comparison information click here |
|||
|
|
|||
|
Truck Tool boxes c/o Hagerstown Metal Fabricators P.O. Box 2887 901 Pope Avenue Hagerstown, Maryland 21741-2887 Phone: 1-301-790-1815 Fax: 1-301-790-2885 Toll Free: 1-866-790-1815 orders@hmfinc.com gkipe@hmfinc.com |
|||
